Shop Now
Choose your car to shop for parts & accessories

In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacements are available to properly restore rust and damage.

Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.

The factory heater and A/C vents on the dash often break or go missing...not to mention the 30+ years of grit and grime they have collected. Restore the dash and get the air directing properly with our 4 piece kit that includes both inner and outer vents. Available in all black or with the chrome band along the edge.

Upgrade your stock dim 80's headlamps with our newest headlamp conversion kit that utilizes replaceable LED bulbs. Having tested many LED bulbs in the past, we have found that these provide far greater visibility at a cost that does not break the bank.

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.

Stiffen your suspension, increase handling and reduce the risk of b-pillar cracks with this rear seat frame brace kit. The more you can stiffen your G-Body, the better.

The factory end caps take quite a beating from damaging sun rays. They get chaulky and can rarely be salvaged. Our new caps are made from ABS plastic and will far outlast the GM originals.

We are happy to report that our exclusive rear speaker panels are back in stock! These panels fit in the back seat armrest area and you can choose a set that hold 4inch speakers for a direct fit or panels that hold up to 6-1/2inch speakers. A great addition to any G-body car for the music lover!

Install one of our 16-gauge powder coated steel drip trays so that you can put the cowl weatherstrip back on like factory. MADE IN THE USA with powder coated 16-gauge steel.

The factory rear shelf is known to warp and rot. Our ABS plastic shelf will last a lifetime and is available in raw plastic or carpeted in your factory color.