78-87 El Camino Parts

Whether you are replacing rusted factory console brackets, adding a center console to a car that wasn't equipped with one or replacing the floor pan, Dixie manufactures all the brackets needed to complete the job

1978-1988 Monte Carlo, El Camino, Malibu, Cutlass, Grand Prix, and Regal black ABS plastic lower kick panel set for non-computer controlled cars (no provision for computer in the passenger side panel).

Dixie has reproduced the coolant overflow tank that GM discontinued in 2018. We have also reproduced the windshield washer bottle at a substantial savings to the GM bottle. Fit, finish and appearance of both are better than the original !

This reproduction cable attaches the heater control in the dash to the pivot point for the blend door on top of the heater box. The clip where it attaches to the heater box typically breaks making your temperature control inoperable. Fits 1978-1988 Monte Carlo, El Camino & Malibu.

1978-1988 Bucket seat outer belt sleeves (pair). These are the plastic trim pieces on the floor that the outboard seatbelts come through.

Many headliners are in stock and ready for immediate shipment! As we approach the end of the driving season, it is the perfect time to beat the rush and avoid long product delays that we see in the Winter/Spring.

Upgrade your stock dim 80's headlamps with our newest headlamp conversion kit that utilizes replaceable LED bulbs. Having tested many LED bulbs in the past, we have found that these provide far greater visibility at a cost that does not break the bank.

Dixie works hard to produce new products but we also continue to improve on existing ones. We are happy to report new lower prices on the same high quality headlight retainers for 4 headlight cars. These hold the headlight to the bucket and are available in chrome or black coated.

This is the rubber and steel piece that holds the window from popping out at speed. It is riveted to the upper front corner of the roof rail retainer. Sold individually, two required per car.

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.