78-87 El Camino Parts

In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacements are available to properly restore rust and damage.

Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.

1978-1988 Monte Carlo, El Camino & Malibu oversized front console change tray. The inside measures 5-1/2" wide and 9" deep. It's approximately twice as big as the factory tray for more practical storage.

Get rid of the sealed beams in favor of more modern replaceable bulbs! This kit uses replaceable H4 bulbs that are brighter, less expensive and more common if you wanted to upgrade to even higher wattage bulbs than come in the kit. Includes housings, bulbs and wiring adapters.

Replace your worn, corroded and non-functioning switches with this all-in-one package which includes the often rusted switch retainers.

This heavy duty aftermarket shaft provides more clearance for larger engines and aftermarket headers.

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.

Dixie has reproduced the coolant overflow tank that GM discontinued in 2018. We have also reproduced the windshield washer bottle at a substantial savings to the GM bottle. Fit, finish and appearance of both are better than the original !

Make your console door look like new again with our reproduction door and hinge assemblies.

1978-1988 Bucket seat outer belt sleeves (pair). These are the plastic trim pieces on the floor that the outboard seatbelts come through.