78-87 El Camino Parts

In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacements are available to properly restore rust and damage.

Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.

1978-1988 Bucket seat outer belt sleeves (pair). These are the plastic trim pieces on the floor that the outboard seatbelts come through.

1978-1988 Monte Carlo, El Camino & Malibu oversized front console change tray. The inside measures 5-1/2" wide and 9" deep. It's approximately twice as big as the factory tray for more practical storage.

These seatbelt sleeves fit the inner female portion of the seatbelts (between seat and center console) and are often lost, broken or faded from age. Great way to finish off your interior rebuild. Sold as a pair and fit bucket seats only.

This injection molded ABS plastic front lower kick panel set is designed to mount a pair of 5-1/4" speakers in place of your factory kick panels.

Make your console door look like new again with our reproduction door and hinge assemblies.

Upgrade your stock dim 80's headlamps with our newest headlamp conversion kit that utilizes replaceable LED bulbs. Having tested many LED bulbs in the past, we have found that these provide far greater visibility at a cost that does not break the bank.

This plastic plug is often lost or broken and covers the bolt that attaches the inner seatbelt.