78-87 El Camino Parts

In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacement are available to properly restore rust and damage.

Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.

This is the rubber and steel piece that holds the window from popping out at speed. It is riveted to the upper front corner of the roof rail retainer. Sold individually, two required per car.

Dixie has reproduced the coolant overflow tank that GM discontinued in 2018. We have also reproduced the windshield washer bottle at a substantial savings to the GM bottle. Fit, finish and appearance of both are better than the original !

This reproduction cable attaches the heater control in the dash to the pivot point for the blend door on top of the heater box. The clip where it attaches to the heater box typically breaks making your temperature control inoperable. Fits 1978-1988 Monte Carlo, El Camino & Malibu.

After being unavailable for many months, we are happy to report that our reproduction ABS plastic inner fender are back in stock for your El Camino, Malibu or Monte Carlo.

This injection molded ABS plastic front lower kick panel set is designed to mount a pair of 5-1/4" speakers in place of your factory kick panels.

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.

1978-1988 Monte Carlo, El Camino & Malibu oversized front console change tray. The inside measures 5-1/2" wide and 9" deep. It's approximately twice as big as the factory tray for more practical storage.

These seatbelt sleeves fit the inner female portion of the seatbelts (between seat and center console) and are often lost, broken or faded from age. Great way to finish off your interior rebuild. Sold as a pair and fit bucket seats only.