78-83 Chevelle/Malibu Parts

These rear window trim panels are finally back in stock! This 4-piece set of trim fits around the rear quarter windows on non-landau 2-door Malibus and is available in all factory colors as well as black.

If you have a bucket seat car with the small tray at the front of the center console, then you know very little fits into it. Upgrade to our new larger tray for more practical storage...it's a great size for modern smart phones!

The factory license plate pocket is very prone to becoming brittle and breaking. Our new durable ABS plastic replacements are a direct fit and will far out last the GM part. Comes raw black and ready for paint.

This is the rubber and steel piece that holds the window from popping out at speed. It is riveted to the upper front corner of the roof rail retainer. Sold individually, two required per car.

Upgrade your stock dim 80's headlamps with our newest headlamp conversion kit that utilizes replaceable LED bulbs. Having tested many LED bulbs in the past, we have found that these provide far greater visibility at a cost that does not break the bank.

This reproduction cable attaches the heater control in the dash to the pivot point for the blend door on top of the heater box. The clip where it attaches to the heater box typically breaks making your temperature control inoperable. Fits 1978-1988 Monte Carlo, El Camino & Malibu.

Dixie has reproduced the coolant overflow tank that GM discontinued in 2018. We have also reproduced the windshield washer bottle at a substantial savings to the GM bottle. Fit, finish and appearance of both are better than the original !

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.

This injection molded ABS plastic front lower kick panel set is designed to mount a pair of 5-1/4" speakers in place of your factory kick panels.

The factory end caps take quite a beating from damaging sun rays. They get chaulky and can rarely be salvaged. Our new caps are made from ABS plastic and will far outlast the GM originals.