Need help finding a part or have a question?
Toll Free 877-243-4943
New lower price on our exact fit injection molded ABS speaker kick panels. Get one of our top selling products and improve your sound system at a new lower cost.
In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacement are available to properly restore rust and damage.
Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.
Install one of our 16-gauge powder coated steel drip trays so that you can put the cowl weatherstrip back on like factory. MADE IN THE USA with powder coated 16-gauge steel.
Dixie has huge selection of everything you'll need to re-seal your classic car!
After being unavailable for many months, we are happy to report that our reproduction ABS plastic inner fender are back in stock for your El Camino, Malibu or Monte Carlo.
1978-1988 Monte Carlo, El Camino, Malibu, Cutlass, Grand Prix, and Regal black ABS plastic lower kick panel set for non-computer controlled cars (no provision for computer in the passenger side panel).
1978-1988 Bucket seat outer belt sleeves (pair). These are the plastic trim pieces on the floor that the outboard seatbelts come through.
Dixie has reproduced the coolant overflow tank that GM discontinued in 2018. We have also reproduced the windshield washer bottle at a substantial savings to the GM bottle. Fit, finish and appearance of both are better than the original !
Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.
After many, many requests, we are finally reproducing these Radiator Isolation Bushings. Sold in pairs, the 1978-1988 radiator isolation bushings are the rubber cushions that fit between the top and bottom of the radiator and the core support. 2 pairs required per car.