Shop Now
Choose your car to shop for parts & accessories

In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacement are available to properly restore rust and damage.

Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.

Get our latest t-shirt design that displays the nose of our '86 Monte SS.

This heavy duty aftermarket shaft provides more clearance for larger engines and aftermarket headers.

1978-1988 Monte Carlo, El Camino & Malibu oversized front console change tray. The inside measures 5-1/2" wide and 9" deep. It's approximately twice as big as the factory tray for more practical storage.

Make your console door look like new again with our reproduction door and hinge assemblies.

The factory end caps take quite a beating from damaging sun rays. They get chaulky and can rarely be salvaged. Our new caps are made from ABS plastic and will far outlast the GM originals.

Dixie has huge selection of everything you'll need to re-seal your classic car!

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.

1978-1988 Bucket seat outer belt sleeves (pair). These are the plastic trim pieces on the floor that the outboard seatbelts come through.