Shop Now
Choose your car to shop for parts & accessories

In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacement are available to properly restore rust and damage.

Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.

Upgrade your stock dim 80's headlamps with our newest headlamp conversion kit that utilizes replaceable LED bulbs. Having tested many LED bulbs in the past, we have found that these provide far greater visibility at a cost that does not break the bank.

This reproduction cable attaches the heater control in the dash to the pivot point for the blend door on top of the heater box. The clip where it attaches to the heater box typically breaks making your temperature control inoperable. Fits 1978-1988 Monte Carlo, El Camino & Malibu.

Replace your faded, cracked or missing interior t-top trim with our direct fit replacements. Available in all factory colors.

We are happy to report that our exclusive rear speaker panels are back in stock! These panels fit in the back seat armrest area and you can choose a set that hold 4inch speakers for a direct fit or panels that hold up to 6-1/2inch speakers. A great addition to any G-body car for the music lover!

After many, many requests, we are finally reproducing these Radiator Isolation Bushings. Sold in pairs, the 1978-1988 radiator isolation bushings are the rubber cushions that fit between the top and bottom of the radiator and the core support. 2 pairs required per car.

Get our latest t-shirt design that displays the nose of our '86 Monte SS.

The factory heater and A/C vents on the dash often break or go missing...not to mention the 30+ years of grit and grime they have collected. Restore the dash and get the air directing properly with our 4 piece kit that includes both inner and outer vents. Available in all black or with the chrome band along the edge.

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.