Need help finding a part or have a question?
Toll Free 877-243-4943
New lower price on our exact fit injection molded ABS speaker kick panels. Get one of our top selling products and improve your sound system at a new lower cost.
In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacement are available to properly restore rust and damage.
Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.
1978-1988 Monte Carlo, El Camino & Malibu oversized front console change tray. The inside measures 5-1/2" wide and 9" deep. It's approximately twice as big as the factory tray for more practical storage.
The factory heater and A/C vents on the dash often break or go missing...not to mention the 30+ years of grit and grime they have collected. Restore the dash and get the air directing properly with our 4 piece kit that includes both inner and outer vents. Available in all black or with the chrome band along the edge.
Dixie has reproduced the coolant overflow tank that GM discontinued in 2018. We have also reproduced the windshield washer bottle at a substantial savings to the GM bottle. Fit, finish and appearance of both are better than the original !
1978-1988 Monte Carlo, El Camino, Malibu, Cutlass, Grand Prix, and Regal black ABS plastic lower kick panel set for non-computer controlled cars (no provision for computer in the passenger side panel).
Replace your broken, leaking and dis-colored coolant reservoir with a new Dixie exclusive piece. Made to OE specs and includes the cap, overflow hose & clamps and mounting hardware.
Make your console door look like new again with our reproduction door and hinge assemblies.
This is a quick and inexpensive way to freshen up your interior. Most original chrome ends are peeling and/or the center caps are missing. Sold as set for both doors, 4 chrome ends and 4 center caps.
Install one of our 16-gauge powder coated steel drip trays so that you can put the cowl weatherstrip back on like factory. MADE IN THE USA with powder coated 16-gauge steel.