Shop Now
Choose your car to shop for parts & accessories

In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacement are available to properly restore rust and damage.

Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.

This plastic plug is often lost or broken and covers the bolt that attaches the inner seatbelt.

This reproduction cable attaches the heater control in the dash to the pivot point for the blend door on top of the heater box. The clip where it attaches to the heater box typically breaks making your temperature control inoperable. Fits 1978-1988 Monte Carlo, El Camino & Malibu.

This injection molded ABS plastic front lower kick panel set is designed to mount a pair of 5-1/4" speakers in place of your factory kick panels.

1978-1988 Monte Carlo, El Camino & Malibu oversized front console change tray. The inside measures 5-1/2" wide and 9" deep. It's approximately twice as big as the factory tray for more practical storage.

Get rid of the sealed beams in favor of more modern replaceable bulbs! This kit uses replaceable H4 bulbs that are brighter, less expensive and more common if you wanted to upgrade to even higher wattage bulbs than come in the kit. Includes housings, bulbs and wiring adapters.

The factory end caps take quite a beating from damaging sun rays. They get chaulky and can rarely be salvaged. Our new caps are made from ABS plastic and will far outlast the GM originals.

This is the rubber and steel piece that holds the window from popping out at speed. It is riveted to the upper front corner of the roof rail retainer. Sold individually, two required per car.