Shop Now
Choose your car to shop for parts & accessories

In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacements are available to properly restore rust and damage.

Exact fit reproduction bezel fits on the driver's side interior lower door panel for cars equipped with the remote mirror adjuster for the passenger side door mirror.

This is a quick and inexpensive way to freshen up your interior. Most original chrome ends are peeling and/or the center caps are missing. Sold as set for both doors, 4 chrome ends and 4 center caps.

Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.

Upgrade your stock dim 80's headlamps with our newest headlamp conversion kit that utilizes replaceable LED bulbs. Having tested many LED bulbs in the past, we have found that these provide far greater visibility at a cost that does not break the bank.

After many, many requests, we are finally reproducing these Radiator Isolation Bushings. Sold in pairs, the 1978-1988 radiator isolation bushings are the rubber cushions that fit between the top and bottom of the radiator and the core support. 2 pairs required per car.

The factory heater and A/C vents on the dash often break or go missing...not to mention the 30+ years of grit and grime they have collected. Restore the dash and get the air directing properly with our 4 piece kit that includes both inner and outer vents. Available in all black or with the chrome band along the edge.

This plastic plug is often lost or broken and covers the bolt that attaches the inner seatbelt.

1978-1988 Monte Carlo, El Camino & Malibu front console gauge pods are now in stock. A great location to add some additional gauges with a finished, factory look.

Install one of our 16-gauge powder coated steel drip trays so that you can put the cowl weatherstrip back on like factory. MADE IN THE USA with powder coated 16-gauge steel.