Need help finding a part or have a question?
Toll Free 877-243-4943
Single speaker door panels are back in stock and less expensive than before. Made from injected molded ABS plastic and each panel fits one 5-1/4" speaker (can use a 6-1/2" speakers with slight modification).
Rear kick panel sets are finally back in stock for your 78-87 El Camino! These ABS plastic reproductions fit on the b-pillar beside the seat(s) and cover the seatbelt mechanism.
Tired of the lack luster music coming from those stock 4" x 10" speakers in the rear? If so, upgrade to 6" x 9" speakers with the help of these direct bolt-in adapters. Speakers not included.
In the past, the only way to repair the floor section under your rear seat was to make patch panels from scratch. Finally, direct weld-in replacements are available to properly restore rust and damage.
Whether you are replacing rusted factory console brackets, adding a center console to a car that wasn't equipped with one or replacing the floor pan, Dixie manufactures all the brackets needed to complete the job
1978-1988 Monte Carlo, El Camino, Malibu, Cutlass, Grand Prix, and Regal black ABS plastic lower kick panel set for non-computer controlled cars (no provision for computer in the passenger side panel).
Make your console door look like new again with our reproduction door and hinge assemblies.
Replace your faded, cracked or missing interior t-top trim with our direct fit replacements. Available in all factory colors.
This is the rubber and steel piece that holds the window from popping out at speed. It is riveted to the upper front corner of the roof rail retainer. Sold individually, two required per car.
Replace your broken or unwanted seatbelt release mechanisms and clean up your door jamb with Dixie's block off plate kit. If you have replaced the stock seatbelts with new modern versions, then you no longer need the factory seatbelt releases located on the door striker posts. The original pieces are often broken and were discontinued by GM long ago. These stainless steel plates can be installed as is, can be polished or painted body color.
The factory end caps take quite a beating from damaging sun rays. They get chaulky and can rarely be salvaged. Our new caps are made from ABS plastic and will far outlast the GM originals.